Knex R700 Sniper

2,506

3

30

Introduction: Knex R700 Sniper

About: Hey, my name is Matt, and i am well known as G-train. That sums up my life pretty much. IF YOU WANT ANY GUNS U WANT ME TO MAKE JUST LET ME KNOW!!!!!!!!! I want to make a AK 47 bullpup (mag behind handle)…

This is an old gun that i made and i've already taken it apart it so i wont post it. It had a good range of around 100 feet. It had a true trigger and trigger guard. Credit to killerk for the trigger mech.
Hope ya like the look of it.
Please rate and subscribe.

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    30 Discussions

    0
    knexjay
    knexjay

    10 years ago on Introduction

    Is picture 2 a BB Gun? If it is i have that it shoots over 650 FPS its so freaking accurate

    0
    Smasher555
    Smasher555

    Reply 9 years ago on Introduction

    Actually that's the Socom Gear R(M)700. $100 at airsoftgi.com.

    0
    headshothoncho

    too bad your stopping making guns, this is nice, a little bad the barrel bends, but most do. so 4.5* nice, BTW I used your stock in my R700 sniper, but I gave you the credit, I hope that is OK

    0
    headshothoncho
    headshothoncho

    Reply 10 years ago on Introduction

    thnx, have you seen mine? :) it turned out pretty dang good I think

    0
    gtrain
    gtrain

    Reply 10 years ago on Introduction

    shoots red rods with a tan connector at the end. i wont be makin guns anymore sorry.

    0
    bennyboy96
    bennyboy96

    10 years ago on Introduction

    can you try and make it again and post instructions :) please XD

    0
    pie25x
    pie25x

    10 years ago on Introduction

    I FIGURED HOW TO MAKE THIS!!!!!!! But I hate the fact that you have only one bullet at a time

    0
    pie25x
    pie25x

    Reply 10 years ago on Introduction

    I really don't know how to post. If you saw my only instructable, you will see I didn't put steps because I don't know how.

    0
    spricer988
    spricer988

    Reply 10 years ago on Introduction

    i know how go to the main menu then there are 4 tabs beside the word INSTRUCTABLES then go to the one that says submit then choose start a new instructable then it tells u steps after u go to that tab

    0
    gtrain
    gtrain

    Reply 10 years ago on Introduction

    the trigger mech is the one off the SRV2.

    0
    054629
    054629

    11 years ago on Introduction

    Can you post this
    It looks really brilliant