Mickey Hanger

364

5

1

Introduction: Mickey Hanger

I had some mahogany left over from a buffet and customized for a bathroom vanity, so I decided to make a mickey hanger for my daughters pin and necklace collection.

Step 1:

After cutting the shapes I needed on the band saw and glueing them together I purchased some wood pins and glued them into corresponding holes. I then used a Forstner Bit to cut slots in the back for Keyhole Fittings for mounting. I stained the silhouette and the base two different shades for some contrast.

Homemade Gifts Contest 2016

Participated in the
Homemade Gifts Contest 2016

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge
    • Origami Speed Challenge

      Origami Speed Challenge

    Comments

    0
    Shyann05
    Shyann05

    5 years ago

    thats something i would like to make for my sister