Moto Penny Board

Introduction: Moto Penny Board

STEPS

1. Clean off penny board so you have a good surface for the leaf blower

2.Get both PVC pipes and make sure they are parallel on each side of the board

3.Once the pvc pipes are in place put the leaf blower in between both of them

4.Screw 2 screws in on each pvc pipe to keep the blower in place

5. Once blower is in place you are free to use it!!!

Supplies

Penny board

powerful leaf blower ( any brand)

5 inch pvc pipes(2)

Electric drill

3 inch screws (4)

Be the First to Share

    Recommendations

    • Tinkercad Student Design Contest

      Tinkercad Student Design Contest
    • Halloween Contest

      Halloween Contest
    • Robots Contest

      Robots Contest

    Comments