My First (good) Knife

Introduction: My First (good) Knife

About: Due to my lack of free time I may take my time to respond to posts/comment etc.

This is actually my third knife. It's a full-tang all-purpose knife that I actually took the time to sand and polish (the first two turned out rubbish). Sadly the photos cannot show it's true shine and brilliance. Some criticism (constructive or not) is greatly appreciated.


Be the First to Share

    Recommendations

    • Explore Science Challenge

      Explore Science Challenge
    • Home Decor Challenge

      Home Decor Challenge
    • Make it Real Student Design Challenge #3

      Make it Real Student Design Challenge #3

    11 Comments

    0
    hominid
    hominid

    11 years ago on Introduction

    I think your photos are fine, well taken. BTW Been in prison {LOL} ?

    0
    Pyro the maniac

    Nicely done! 2 questions from a fellow novice knife maker 1. what type of steel do you use and do you harden it or just use as is? 2. What do you use for grinding it Nice job Pyro

    0
    super moderator
    super moderator

    Reply 11 years ago on Introduction

    Thanks! My first 2 knives were made from mild steel. The good knife is made from carbon steel (a lawnmower edger blade from Bunnings) and I didn't harden the knife (no forge) but as my dad only uses it for gardening it's under no real stresses. To cut out the basic shape I used an angle grinder then a bench grinder for deatails but a jewllers saw would work fine. Good luck! Moderator

    0
    super moderator
    super moderator

    Reply 11 years ago on Introduction

    Yea I know, it's mainly for whittling so the big hand is comfy and the small slim blade is for delicate jobs.

    0
    hominid
    hominid

    11 years ago on Introduction

    I see that by your Px posts you are a gardener, Is this knife for grafting, if so maybe you could do an instructable on that too?

    0
    super moderator
    super moderator

    Reply 11 years ago on Introduction

    This knife was not intended for grafting but as I have little experience in grafting (my dad has a bit) I am not sure if it can be used for grafting. As for the Instructable did you want it on the knife or grafting?
    BTW check this out.