Introduction: Nerf Flash Light Attachment
this is a flashlight attachment that can be taped to a nerf blaster etc. has a case in case it falls.
A nerf gun (preferably one with a large surface on the side of it) ,Card board, good sticky tape, and a flashlight with a button on the back
Step 1: Collect Supplies
Step 2: Construct Base
cut out a rectangle with enough length to cover the flashlight length wise.tape the flashlight to the cardboard
Step 3: Second Rectangle
Cut another slight smaller rectangle, then tape it to the main base (as shown).
Step 4: Final Rectangle
cut a rectangle large enough to cover the remaining gap cover gap
Step 5: Tape It to the Nerf Blaster