Introduction: New Knex Concepts (#6) Hammer Guns
Guns:
1: Hammer Gun 153: A gun that uses an elastic powered spinning mech to fire a rod. The rod is held in place by a mag pusher. In addition to the hammer, the spinning part has a short rod jutting from it that will strike the bullet when the trigger is pulled. This part also doubles as something for the trigger block to stop. The hammer should rotate 180 degrees (half a circle) when it is cocked.
2: Hammer Gun 536: Works the same as Hammer Gun 153, but uses a ratchet mech instead of a true block trigger.
13 Comments
10 years ago on Introduction
Now you have to look down 2 comments
11 years ago on Introduction
I AGREE WITH PRODO! look down one comment!
12 years ago on Introduction
you could technically make a 4-shot burst gun with a mech like this.
12 years ago on Introduction
I used the system in my magnum concept thingy
Reply 12 years ago on Introduction
I just took a look at yours and it's similar, but my setups get more than double the range of motion so will be more powerful.
12 years ago on Introduction
I've made a similar gun to the ratchet mech one, but it wasn't powerful...
12 years ago on Introduction
im confused is the concept like a swinging lever witch hits a rod or what
Reply 12 years ago on Introduction
The large lever cocks it, the small lever hits the bullet.
12 years ago on Introduction
I made a true hammer revolver, it used the BR8 barrel, because all you need to do is push it.
12 years ago on Introduction
cool
12 years ago on Introduction
really cool i tried making a hammer gun awhile but it worked on using a rubber band gun mech that should've hit the round outta the barrel.i might have to try idea 2 if i get the chance.
12 years ago on Introduction
interesting. hammer guns are kina useless though.
Reply 12 years ago on Introduction
Absolutely not, with a sturdy hammer for pulling lots of elastics and a wide range of spin, it's a short barreled alternative to other guns.