Introduction: Non-Tangle Ear Buds!
This Instructable will show you how to tie your ear buds so they won't tangle. This is my first Instructable, so enjoy!
Step 1: The Grip
Pinch the wire just below the ear buds with your thumb like so. Do not let go.
Step 2: The Wrap
Wrap the cord in a figure-8 pattern in between your index and pinkie finger, untill there are about 2-3 inches left in the cord.
Step 3: The Cross-Wrap
Wrap what is left of the cord between the index and pinkie fingers, untill there is only the jack left.
Step 4: Finish
Take out your pinkie and insert the jack through the hole where it was. pull tight.
Step 5: To Undo:
Remove the jack from the pinkie hole, then pull on the buds and the jack