Introduction: Printer Fish
This sculpture was made from a disassembled printer and a fish mobile. The buttons on the printer were used to make the fish's eyes, wiring was used to make waves, the top of the printer formed the ocean floor, and the circuit board serves as an underwater plant.
![Green Electronics Challenge](https://content.instructables.com/FNV/ROBX/HTPUMU5B/FNVROBXHTPUMU5B.jpg?auto=webp&frame=1&width=320)
Participated in the
Green Electronics Challenge
![Full Spectrum Laser Contest](https://content.instructables.com/F22/38OA/HRCK0Z3B/F2238OAHRCK0Z3B.jpg?auto=webp&frame=1&width=320)
Participated in the
Full Spectrum Laser Contest