Introduction: Single Chain Rainbow Loom Bracelet

This is a very simple bracelet to make and you can also do this without the loom!

Step 1: Materials

You will need:

-a loom (if you don't have one I will show you how to do it on your fingers)
- a hook
- 25 rubber bands
- and a c/s clip

Step 2: Placing the Bands

First, place one band from the very bottom to the one to the right and then place a bands to the left and keep doing this until you reach the very top!

Step 3: Time to Hook!

Turn your loom around and let start hooking! The hooking step is super easy so you should maybe get it right at first but it's ok if you don't! Reach under the last bands and go all the way under and get the very bottom band and hook it to the next pin! Do that until you can't hook anymore!

Step 4: Finishing the Bracelet!

Get a c or s clip and attach it to the bands at the red arrow and take it off the loom! Then, attach the other end of the x/s clip and put it on the other end of the bracelet!

Step 5: Now You Are Done!

Now you are done your bracelet! I hope you liked this! Comment down below if you did or didn't like this an tell me how I can improve!

Thanks you and goodbye!! :D