Small Catapult

By in OutsideSiege Engines

2,289

48

4

Introduction: Small Catapult

By

This small catapult is about 5 cm x 10 cm and using 1 piece of rubberband.

It is functional, but I made it from scratch and for desktop display.

The wood I used is 0.5cm square rod.

The "pocket" is the cap from laser pointer.

The "wheel" is small chess.

The "wheel axis" is toothpick.

They are sticked together with hot glue.

Cheers.

Rubber Bands Challenge

Participated in the
Rubber Bands Challenge

Be the First to Share

    Recommendations

    Stitch and Glue Canoe With Cedar Strip Top
    Stitch and Glue Canoe With Cedar Strip Top by georgechapman in Water
    45 4.0K
    Be Seen! 3D Printed Bike Lights With Fusion 360
    Be Seen! 3D Printed Bike Lights With Fusion 360 by Kevr102 in Bikes
    32 4.6K
    Building a Backyard Rocket Fort
    Building a Backyard Rocket Fort by Garage_Shop_Crafter in Woodworking
    56 5.4K
    Buggy Trike
    Buggy Trike by uersel in Bikes
    109 13K

    • Origami Speed Challenge

      Origami Speed Challenge

    • Woodworking Contest

      Woodworking Contest

    • Chocolate Challenge

      Chocolate Challenge

    4 Comments

    0
    tomatoskins
    tomatoskins

    7 years ago

    Well this is a nice looking catapult! If you have any during construction pictures those world be lovely! What did you use for the "cup"?

    0
    kokpat
    kokpat

    Reply 7 years ago on Introduction

    Sorry, that's all the photo I had taken.
    I use BB bullet or just a little bit eraser for the "cup".

    0
    Mr AbAk
    Mr AbAk

    7 years ago

    Nice Catapult...