Picture Frame Out of Old Hard Disk and CD

Introduction: Picture Frame Out of Old Hard Disk and CD

About: i am a "Philomath", a lover of learning

Hi :)

this is very simple DIY that I tried while ago and finally only now got the chance to share it with you all, hope u like it!
the images are pretty much self-explanatory and what i needed for this project is the following:
•Old Hard disk
•Old CD
•electric copper wire
•screw drivers
•super glue

via screw drivers i took off the circuit board that covers one side of the hard disc and i found this amazing color combination of  Green and Copper...it was no brainy for me to use it for something geeky and beautiful!

i cut 2/3 of the CD, made 2 holes in it and attached to the circuit board using the copper wire. What left of the CD I super glued it to the bottom of the circuit board to support it and make sure that it would stand still.

All the best.

Be the First to Share

    Recommendations

    • Arduino Contest

      Arduino Contest
    • Barbecue Speed Challenge

      Barbecue Speed Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest

    2 Comments

    looks great! is the 1/3 CD enough to support it, or do you think you would have added more next time?

    0
    Kawthar Xoubi
    Kawthar Xoubi

    Reply 8 years ago on Introduction

    thank u amandaghassaei =) actually the bottom of the circuit board is about 1 cm wide which is good enough for the board to stand and attaching the 1/3 of Cd reinforce the board stability.