Sugru GoPro Screw

Introduction: Sugru GoPro Screw

Instructables sent some Sugru to Milwaukee Makerspace for the July 2013 Build Night and I made a nice screw for my GoPro.

I used an M5 x 40 bolt and molded the Sugru around it to act as a grip so I can easily screw it into place with my fingers.

I'm using it with a 3D printed tripod mount I made, since the stock bolt that GoPro makes is just a little too short.

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Microcontroller Contest

      Microcontroller Contest

    Comments