Tealight Holder

Introduction: Tealight Holder

I made a little tealight holder with the 3d printer. 

Step 1:

First I made a drawing in Rhino. My starting point was a cilinder. 
The diameter is 50 mm. The height is 30 mm. 
Then I put some geometric figures on the side. 

I made it with the Ultimaker and it took me about 40 minutes to print it. 
I used the color silver to print it. 

Step 2:

Be the First to Share

    Recommendations

    • Build a Tool Contest

      Build a Tool Contest
    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest
    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge

    Comments