Introduction: Touch Not Bell
In this tough time when whole nation is fighting from this pandemic and where social distancing is must so i have come with handmade sensor bell system. In INDIA for every 1 kilometres there is one temple as our nation is full of culture and devotes so i thought of this project as everyone after entering temple they touch bell as in this pandemic is not correct so had to think on it.
Supplies
IR Sensor
TIP32C PNP Transistor
1k Resistor
12v motor
USB cable
Temple bell
Acrylic sheets
Wires
Wheel
Screws
To start this project you need all the above materials
Step 1: Connection
As the above connection shown connect the wires from
IR sensor positive terminal - transistor E - positive terminal of USB cable
IR sensor negative terminal - DC Motor +ve - transistor C - DC Motor - negative terminal of USB cable
Output of IR sensor - 1k resistor - transistor B
Step 2: Hardware
Pick up the acrylic sheet and cut some of the strips (5) and one in the shape of circle and some drill as shown and please watch video carefully and observe and cut the acrylic sheet where ever required ,later assemble everything together and join as in video Drill properly as there should not be any disturbance or friction in movement.
Step 3: Done!
Here is the project ready no touch bell to overcome this pandemic and social distancing.
Thank you!!