Introduction: A Cheap and Beautiful Rc Car
The car is cheap and made of materials available nearby.
If u have any problem then u can ask me .
Leave a nice comment.
If u have any problem then u can ask me .
Leave a nice comment.
Step 1: Material Required
Cardboard
Sticks
DVD drive (broken, not new but the motors are OK)
Transmiitor and receiver
LEDs
Gear box of a good ratio for better toque
I big gear
Tyres
I hollow tube
Fevicol , feviquick, papers
Colours and simple tools
Sticks
DVD drive (broken, not new but the motors are OK)
Transmiitor and receiver
LEDs
Gear box of a good ratio for better toque
I big gear
Tyres
I hollow tube
Fevicol , feviquick, papers
Colours and simple tools
Step 2: Making Frame
Make a wooden frame out of sticks and make sure that the wood is not heavy.
Our moto is to make light frame.
From the DVD drive take out a motor which is without gears and place it in the gear box .
I made my gear box at home using some plastic parts and gears. Officially I did not do any calculations for gears but use my hands to understand them.
Our moto is to make light frame.
From the DVD drive take out a motor which is without gears and place it in the gear box .
I made my gear box at home using some plastic parts and gears. Officially I did not do any calculations for gears but use my hands to understand them.
Step 3: Body
The body is made of card board and attached with frame.
Step 4: Stearing
The strstearing is made of DVD drive and the bigger gear I attached a metal peice in the center and attached a refill to it . I attached two tyres to the refill and make sure it runs free.
Step 5: Back Power
Attach the other gear box and motor to the back of vehicle . attach wheels to it
Step 6: Power
Wide up the reciver to the motors . it is very easy so I am leaving it.
Step 7: Colour
Colour the car as you wish and run it.
You can also use LEDs .
You can also use LEDs .