Almost Finished Mp5k

Introduction: Almost Finished Mp5k

About: May The Long Time Sun Shine Upon You, All Love Surround You, And The Pure Light Within You, Guide Your Way On

After seeing motabois mp5k i tryed to build it from the one picture he has of it here. https://www.instructables.com/id/My-Guns-Current-and-Upcoming/ 
so far this is what i have done
body of the gun
the front handle and grip
ram guide and a trigger(i'm not sure how well the trigger works because i don't have enough hinges)
magazine 
trigger guard
and a part of the mag well
so id appreciate any feedback on it and i'm open to any ideas of how to improve the gun.

Be the First to Share

    Recommendations

    • DIY Summer Camp Contest

      DIY Summer Camp Contest
    • Maps Challenge

      Maps Challenge
    • Fruit and Veggies Speed Challenge

      Fruit and Veggies Speed Challenge

    13 Comments

    0
    TheKnexPro
    TheKnexPro

    2 years ago

    Get real. Why bother to post a half finished instructable? Geez…

    0
    tubanator-2.0
    tubanator-2.0

    Reply 11 years ago on Introduction

    yea i just looked at it looks alot better than this one in some spots. but after a while i just gave up on trying to make this work i might try again with different internals another time.

    0
    Raikou-san
    Raikou-san

    11 years ago on Introduction

    I'll be honest. I really like the handle and trigger guard, but not much else. I think if you could add a good front grip instead of just a yellow rod, and work on the frame a bit and use a connector barrel (with orange connectors), it would look a lot better.

    0
    tubanator-2.0
    tubanator-2.0

    Reply 11 years ago on Introduction

    the yellow rods were just a temporary thing when i was building it. as for the barrel i'll probably have to make something because i still can't get any rounds to feed with either flying every where in the gun/ram not reaching them.

    0
    Raikou-san
    Raikou-san

    Reply 11 years ago on Introduction

    The connector barrel would probably fix the feeding problem since the ammo would just hit the barrel ceiling, and then the ram would hit it.

    0
    tubanator-2.0
    tubanator-2.0

    Reply 11 years ago on Introduction

    yea when i was uploading it i had a lot of problems seeing the pics. well heres 2 over view pics one of the internals and one of how i have made now.i also might make it into a H@K usc.

    0726102159a.jpg0727102310a.jpg