Hang-up Guitar Stand From Rubber Handcuffs

Introduction: Hang-up Guitar Stand From Rubber Handcuffs

 I really needed a stand for my guitar but i didnt have any money so i went to my basement and found some rubber hand cuffs and got a genious idea. so here it is....

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: What You'll Need...

Hedge Clippers
Screw Driver
Two nails

Step 2: First, Cut the Cuffs!

First you'll need to cut the cuffs, using the hedge trimmer.

Step 3: Next, Make a Small Hole Through the Cuffs.

Using the screw driver, puncture a hole through the cuffs.

Step 4: Then, Insert the Nails Through the Holes.

Next, with the holes you made just push the nails in. this should be easy.

Step 5: And You're Done!

now all you have to do is scew them in the wall you want your guitars to hang. just slide the head stock through the rubber cuff( this may not be so easy for some guitars...)

Be the First to Share

    Recommendations

    • Toys and Games Challenge

      Toys and Games Challenge
    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge

    2 Discussions

    0
    Brother_D
    Brother_D

    9 years ago on Introduction

    Nice ax. This seems a bit dangerous, how sturdy is it?

    0
    longboardboy
    longboardboy

    Reply 9 years ago on Introduction

    Well the first time i tried the screw was not so strong but if you add expansions the whole thing is pretty much un breakable. also consider that the rubber is half an inch thick.