Tealight Holder

I made a little tealight holder with the 3d printer. 

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

First I made a drawing in Rhino. My starting point was a cilinder. 
The diameter is 50 mm. The height is 30 mm. 
Then I put some geometric figures on the side. 

I made it with the Ultimaker and it took me about 40 minutes to print it. 
I used the color silver to print it. 

Step 2:

Be the First to Share

    Recommendations

    • Book Character Costume Challenge

      Book Character Costume Challenge
    • Made with Math Contest

      Made with Math Contest
    • Cardboard Speed Challenge

      Cardboard Speed Challenge

    Discussions