IPhone Jack

Step 1: Materials

Scissors , Old pair of headphones and an iPhone /iPod charger of your own mine an iPhone and iPod 4

Step 2: Cutting the Edges

First you need to take your headphones and charger and cut off the charging end and the jack end and sorry the input ends (my bad)

Step 3: Maybe

Your charger may have a case around it cut it off or not your chose I did

Step 4: Then Your Done

I just saved you a few dollars if you have that stuff laying around , make sure you don't plan on using these items again its used to keep sand and stuff like that out my dad lives near the beach and make sure to comment favorite and last but not least subscribe I my YouTube channel a lot of snowboarding this season and a few how too's thank you -Bumbumshack

Share

    Recommendations

    • Cardboard Challenge

      Cardboard Challenge
    • PCB Contest

      PCB Contest
    • Epilog X Contest

      Epilog X Contest

    8 Discussions

    0
    None
    karimbaltaji

    4 years ago

    Does it need to be an iPod 4

    0
    None
    karimbaltaji

    4 years ago

    Does it need to be an iPod 4

    0
    None
    rodski

    4 years ago on Introduction

    Better to put some masking tape on all open port,.instead of wasting all those usable connectors for other diy stuff.

    0
    None
    sbarnett6

    5 years ago

    I'm not seeing any sort of logic or goal to this instructable...

    0
    None
    crawlinson

    5 years ago

    It's suppose to keep the sand and dirt out when your at the beach

    0
    None
    Guitarjose

    5 years ago

    I'm sorry but the headphone and the iPod charger are practically useless without the cables.

    0
    None
    acuchetto

    5 years ago

    Yeah, what?