Tell us about yourself!
just connect one wire from the switch to the positive on the light, and 1 wire to the positive on the plug. Than just connect the negative from the plug to the negative of the light. Don't forget to use lots of heat shrink tubing, and if u are soldering the wires, make sure you have a good connection!
Wrong use the positive.
just connect one wire from the switch to the positive on the light, and 1 wire to the positive on the plug. Than just connect the negative from the plug to the negative of the light. Don't forget to use lots of heat shrink tubing, and if u are soldering the wires, make sure you have a good connection! Do not connect one to positive and 1 to negative of plug, when you would turn it on, it would short it out,
Use one that has 2 wires only, and make sure you have at least a few amps. Other than that, it shouldnt matter.
You should call the operating system Arduinoid (Arduino Android) lol
lol i know what u r saying exactly i always comment on cardboard safe videos 2
Do you mean plasma lighter by tazer, and why cant u use one? What kind of fuel is being used?
Make a nitro version lol
Yay! The King Of Random! Where is the fire though?
the more wattage you have, the faster the battery would charge, i would recommend not less than 20 watts for a 18ah battery.
If you are using this for charging usb devices, instead of using a voltage regulator, use a usb charger, the kind you plug into your cars 12v port, and connect it the same way as the inverter. They are cheap if you dont already have a few laying around, and they have more protection for the phone.
in the additional wiring photo in the last step, you have the 2 solar panels in series, making 24v. This is a 12v system, even when using the 2 6v batteries as seen in the photo, so put the solar panels in paralel instead.
no, the relay is DC, but it is not controlled by the AC, it is only controlled by the dc from the sterio.
yes, I think that is usually compressed air. I wou thought that I might be able to do the same thing with water, but in order to have enough pressure to fill a balloon could be hard. The balloon would not need to be standing straighgt up, I could put the thingey you put the balloon on facing down, but it would be good if it could be standing up. It is a clown like the normal ones, but it is painted on to a piece of plywood. Thanks for the comment and the link.