SpitfireGirl

I don't know but that would be a good guess if you've taken it all apart and cleaned thoroughly. Or perhaps it is simply displaced, not seating properly. Sorry I could not be of more help. Perhaps someone else reading this knows.

Wonderful! I *am* a vet, great job. If you want a soft variation, take a look at my instructable for Mikey the cat. https://www.instructables.com/id/Custom-shoe-for-a-pet-who-knuckles/ I am amazed how much custom commercial versions cost and am glad to hear of another special pet and owner.

Wonderful!

I'm glad you finally fixed it. You are so welcome!

Hi, I myself used baling wire with the ends bent into a circle (prevents sharp ends), but we also discussed in our household snipping strips from beer or soda cans and folding the sharp edges inward. Good luck!

Hi there. I took a look at the only one of these I have, and it didn't pull off easily. I found that the clear plastic does twist a little bit apart from the white plastic, confirming they are not adhered together. I held the white part tightly and gently pressed on the corner of the clear barrel part, like I was trying to pry it off. Popped right off. To reinstall it, I simply screwed the top on the bottle and it popped into place. Good luck!

You're welcome!

It sounds like your mesh is clogged with soap goobers. Try taking the little cylinder out and cleaning off the 2 mesh ends. Good luck!

Boot stays: Keeps my fancy leather boots upright and avoids creasing. Often these go on sale a Walmart for a quarter at the end of the summer. Thanks for your post!

Sealed the mesh into the cylinder, wow you went above and beyond. Thanks for sharing!

I haven't seen this lining-up problem before, and I'm afraid I've shared all the info I know. Sorry, good luck!

Yaaaaayyyy! Good work!

You are very welcome. Vexing until you find that magic foam-making mesh.

Thanks for the comment! Lately we've been using those red cylindrical coffee tubs. Easy to cut, built-in snap-on lid. Easy peasy, happy foraging!