Tell us about yourself!
Hi ! I finally managed to print driver-shoulder-joint ( after your changes ), but I have now similar issue with driver-upper-arm-with-pauldron.stl. Could you please extend a little bit gap for this part too ? Thanks in advance.
Hi Ossum ! I created new case for CM275T. See picture. Do you want to add this part to your guide ?
You can for sure upload it to myminifactory https://www.thingiverse.com/thing:3427003
Thanks a lot. Another question. Seems with my printer is not possible to print driver-shoulder-joint-body side.stl. For sure I can print it, but for me it is not movable. Is it possible for you to create new version of this part, where gap between 2 parts will be a little bit bigger.
Hi Ossum ! Seems I found one small mistake in your STL files. File driver-base-use-supports has a slope 1 grad to the X axis. I rotated it to the -1 grad back and after that I can print it without any problems.
Hi Ossum ! I have no experience how to control continuous rotation servo with th9x.Could you please help me or navigate to any guides about. Second question is minor enough.I did find place where to put bushing-15x10x4.stl.Thanks in advance.
Seems 20 according pictures.
Reflow Oven With ControLeo3View Instructable »