Tell us about yourself!
I bought the paint from homedepot. It is baer brand paint.
3" 350lb full lock c
I can add some of my final measurement but it will be subjective to the tools you use and your height. The table is 36in total height. The top piece is 6ft by 40"
Have put over 500lb on it with out issue. I don't foresee it being a issue. The half laps are supported by the 2x4 that runs through them. I believe it will be fine
You could always place wheels under the table saw but I haven't had a issue yet. The poly should last a few years. You can always sand it with 220 and add another coat to make it look new again
That was my issue as well. Plus sometimes I roll this outside and work in the driveway so it is nice to not have to run mutilple cords outside. I rarely use more then one tool at a time so I'm not sure I'll experience what the other person was commenting on. This has worked well for me.
I have not had any sagging issues with the table saw. So far it is staying square and level. As far as the top it is just double 3/4 that is screwed together. That way it is replaceable with out having to Shane the piece under it
No issues with sagging so far. I'll keep my fingers crossed
Yonatan24. The table saw is flush with the table top and functions as a outfeed for the saw.
Thank you all
All in One Work Bench
Thank you. Lmk of you have any questions
All In One Work BenchView Instructable »