shashankvkt8

Thanks for your interest. The code is available at:https://github.com/shashankvkt/Object_trackingIf you find the code useful, kindly consider starring it. Also, feel free to ask me if you have any queries.

Yes definitely!!Good Luck with your project! In case of any doubts please feel free to contact.

Without pixhawk?

It was along time back. Actually i know that you can buy any gimbal which supports Storm32 BGC which is essentially a gimbal controller board hooked up with your gimbal to send and receive signals from your pixhawk. You can google about storm32 BGC. Hope this helps!Feel free to inquire if your doubts are still not cleared.

Thats funny. How would you send and receive flight commands such as roll pitch yaw? or take off or land?

Thank you for your interest!In fact you could use any 3-axis gimbal of your choice connect it to the pixhawk and send commands to it via mavLink

Hello!unfortunately, Rpi3B would slow down the image processing process. Ive used Odroid XU4 with 2GB ram which actually could handle fast image processing in the drone.

1. A F450 quadrotor2. Odroid XU4 - Image processing and sending commands to Gimbal3. Pixhawk PX4 - autopilot4. 3-axis Gimbal (Storm32 BGC) 5. Sj4000 Camera6. Connecting wires7. GPS module8. LiDAR9. Barometer

Thank you for your interest.Honestly speaking I cannot dedicate my time completely to guide you on this. However can assist you partly. You can find the code on my Github page for reference.

Thank you very much.You can find a part of the code on https://github.com/shashankvkt/Object_trackingif you find the code useful...you can share express appreciation by giving a star to the repository. Thank you once again

Thank you for your feedback sir!

Thanks for the invitation!!I'll be really honored to judge a "Tech" related contest.

I'm glad you liked it. Thank you for your feedback :-)

Thank you!

its amaziiiiiiiinnnnnggggggggg!!!!!!!!!!!!!!!

if u could also share this on diy drones it would be great! The drone community could recognize your work.hope it helps. cheers

this is really cool. I too have used odroid xu4 and pixhawk integrating it with ROS in my project if u could kindly check it out (https://www.instructables.com/Vision-Based-Object-Tracking-and-Following-Using-3/).

Thank you! appreciate it

Thank you!

Thank you so much!