Introduction: Mepain's Loser Rifle

This instructable will be done in three parts-the basic version of the gun, the intermediate addon, and the expert long barrel. The basic version will still work even without some of the added support. Because of the lack of time i have, only the basic and intermediate versions will be posted now. The rest will have their own release dates in the future.

Step 1: Step 1: Basic Ver.

We will begin by making the handle. Pictures 1 and 2 are the same thing, do NOT make 2 of them. Pay close attention to picture #5, there is a green rod in the connectors, it should stay there.

Step 2: Step 2: Basic Ver.: Butt and Slide

Here you will make the butt and slide, as the title suggests. Pictures 1-8 are the butt. Pictures 9-21 are the slide.

Step 3: Step 3: Basic Ver.: Barrel

Here's the barrel of the gun (part 1). Build these parts.

Step 4: Step 4: Basic Ver.: Barrel (cont.)

Step 5: Step 5: Basic Ver.: Barrel (cont.)

This is the top part of the barrel, where the scope rests.

Step 6: Step 6: Basic Ver.: Firing Pin

Step 7: Step 7: Basic Ver.: Add Firing Pin

I couldnt find the right picture, so i had to use this one.

Step 8: Step 8: Basic Ver.: Put It All Together

enter longer description for this step

Step 9: Step 9: Basic Ver.: Rubber Bands

enter longer description for this step

Step 10: Step 10: Basic Ver.: Pin Cover

Step 11: Step 1: Intermediate Addon

This is step one of the intermediate addon. Build these parts.

Step 12: Step 2: Intermediate Addon

Here you'll put the parts you built in the previous step together.

Step 13: Step 3: Intermediate Addon

Step 14: Finally, the Last Part of the Sniper.

Yes! The site is working again.

Step 15: Hehe, Time for That Long Barrel!

I don't have too much time to type so I'll just post the rest of the instructions for right now.

Step 16: Ggh


Step 17: Finish It Off.

Connect the forgrip and extended barrel to the main gun.

Step 18: Loading

Step 19: The Sight

The sight is pretty easy to make. You could make it from a few pics.