Awesome Knex Crossbow

Introduction: Awesome Knex Crossbow

Here is my first instructable so I hope ya like it. I have been working on this for awhile and now I finally finished it! Please no bad criticism but I will accept nice criticism and ideas on how to make it better! :)

Step 1: The Track

Put together 5 yellow connectors end to end and connect with green rods. Do this four times. Attach blue rods to the first set of yellow connectors as shown in pic 3. Put light blue rings on blue rods then attach a second yellow connector set next to blue rings. Now you need to make a stick using 5 orange connectors and green rods like in pic 4. Attach the orange stick to the blue rods through the orange connector holes. Then you add another yellow connector set next to the orange stick and blue rings and the last yellow sets it looks like the first pic.

Step 2: The Bow

Pic 2: make 2 of these.
Pic 3: add blue rods in these places.
Pic 4: attach like so.
Pic 5: attach these in the correct order.
Pic 6: do this on both sides.

Step 3: Connecting!

Attach blue rods to the end of the track.
Then push blue rods through the holes in the orange connectors on the bow. Then attach grey and blue rings as shown. Add the end caps and your done with this step!

Step 4: The Trigger System

Pic: 1 make this.
Pic: 2 attach it here.
Your done!

Be the First to Share


    • Microcontroller Contest

      Microcontroller Contest
    • Plywood Contest

      Plywood Contest
    • Fandom Contest

      Fandom Contest



    2 years ago

    The rubber band placement is pretty simple to so you should be able to figure it out


    2 years ago

    Sorry forgot to mention bullet design. Here it is. Put brown spike In track wen shooting.


    2 years ago

    Can you give me your opinion?