Bracelet and Box

Introduction: Bracelet and Box

Grab Materials

Step 1: Cutting and Tieing

2. Cut 3 equal cuts of string each with exacto knife. 10 inches per string.

3. Tie a knot into the string at the top. Begin to braid.(placing tape on knot helps)

Step 2: Add Hex Nuts

5. Begin to add hex nuts to the string that alternates.

Step 3: Knots and Clamps

6. Braid to end of string. Tie another knot at other end to keep hex nuts from falling off.

7. Add clamps to help clip bracelet ends together.

Step 4: Cutting

1. Cut 5, 9 by 3 planks of wood.

Step 5:

Be the First to Share

    Recommendations

    • Fashion Challenge

      Fashion Challenge
    • Make it Move Challenge

      Make it Move Challenge
    • Tinkercad Student Design Contest

      Tinkercad Student Design Contest

    3 Comments

    0
    Joblack18
    Joblack18

    Reply 6 years ago on Introduction

    Unfortunately, no. Our finished box was not able to be taken a picture of. Seamster.

    0
    Joblack18
    Joblack18

    6 years ago on Introduction

    Unfortunately, no. Our finished box was not able to be taken a picture of. Seamster