DIY Dice Tower Out of a Pringle Chip Can

6,258

9

1

Introduction: DIY Dice Tower Out of a Pringle Chip Can

Welcome and please Vote for This instructable.

Step 1: Get a Pringles Can

This is near the End of it Yet... Grab that can take the lid and Cut it in half

Cut at an angle 2 Holes then find A plastic Scrap and Cut a slider at the Top Cut a hole at the Bottom and You can customize the Rest to make a 5 minute Dice Tower

Step 2: Thanks for Being INSTRUCTED

This Is for DND (Dungeons and Dragons). I created it so that I didn't have to Throw my dice over and over and over again.

Be the First to Share

    Recommendations

    • Audio Challenge

      Audio Challenge
    • Unusual Uses Contest

      Unusual Uses Contest
    • Micro:bit Contest

      Micro:bit Contest

    Comments

    0
    ronanry
    ronanry

    2 years ago

    Really great idea !
    I had the idea to make i with toilet paper but it's too small...i however don't think of pringle can. Thx !!