Introduction: Geears of War 2 Lancer
This is a replica Gears of War 2 Lancer.
This took me two afternoons to build.
This is my first Instructable so please leave feedback.
It is very fun to make two of these and use them
to "Chainsaw duel" as seen in Gears of War 2.
.
So, lets get ready to build........
Step 1: Piece Count
Here is a piece count...
This piece count may not be all correct,
but it is pretty close.
Here it is.....
Rods,
Grey = 1
Red = 14
Yellow = 18
White = 132
Green = 132
Connectors,
Green = 68
Yellow = 46
Red = 20
Blue = 13
Purple = 14
Orange = 20
White = 19
Light Gray = 4
Dark Gray = 8
Misc.,
Gray Gears = 9
Blue Spacers = 3
Gray Spacers = 3
Black Wheels = 3
Y Clips = 5
Black Tip = 1
Full Hindges = 5
Theres the Piece count!
Step 2: Bottom of the Front
Make picture one,
Add picture two to picture three,
This is a two layer lancer so look at picture four it shows how,
At the end this piece will look like picture five.
Step 3: Front Top
Make picture one, (This is also is two layer)
Add picture two to picture one,
This should Look like picture three.
Step 4: Misc. Parts
Make picture two, (This is two layer)
Make picture three and four, (This is the the same piece in two pictures)
Make picture five, (This is also two layer).
Step 5: Back
Make pictures 1, 2, 3, (This is one piece but in three pictures).
Step 6: Putting It All Together
Just follow the pictures one through thirteen and you'll have it together in no time!