Halo Plasma Rifle

Introduction: Halo Plasma Rifle

About: Nobody ever reads these things...... exept for you.... you're doing it right now... good for you...

This is my first instructible, it is a foam model of a halo plasma rifle. It is made of a special foam insulation that you can buy at any hardware store.It was cut with a "stanley" knife with a break-off blade. It took me about two days to make and paint.
I built the whole thing for about $15.

Halloween Photo Instructable Contest

Participated in the
Halloween Photo Instructable Contest

Halloween Props  Contest

Participated in the
Halloween Props Contest

Be the First to Share

    Recommendations

    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge
    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge
    • Leather Challenge

      Leather Challenge

    5 Comments

    0
    Attmos
    Attmos

    10 years ago on Introduction

    Nice work, really cool looking. Its too bad you don't have some photos of it's construction. I'd like to have seen it's formation.

    0
    Attmos
    Attmos

    Reply 10 years ago on Introduction

    Yeah, I've got several like that too. I was just given you crap, playin around.