Hogwarts House Cup-mashup

Find a Hogwarts crest on Tinkercad. Also, find a goblet.

Supplies

I could not find a goblet that fitted my needs, so I use a trophy that was made by "Lanie_Athena" on Tinkercad and took off the handles. The Hogwarts crest was made by "ingenio 7".

Step 1: Crest

Change the crest dimensions to 1 inch by 1 inch. Copy and paste the Hogwarts crest, until you have four crests.

Step 2: Assemble

Place the crests around the goblet, that is 2 inches high and 1 inch in diameter on the bottom.

Step 3: Finished

It is finished, but if you want to print it, on a 3d-printer, the house cup should be turned upside down.