Introduction: How to Make a Starburst Bracelet on the Loom!
Step 1:
Placing the bands:
Step 2:
Placing the bands
Step 3:
Go all the way up until your loom looks like this:
Step 4:
Then you do the other side:
Step 5:
Placing the burst bands:
Step 6:
Then you do the same thing going clockwise.
Step 7:
And you do the same thing all the way up.
Step 8:
Flip the Loom around.
Step 9:
Placing the capping bands, make a figure 8 and fold it back upon it's self.
Step 10:
Actually placing the capping bands.
Step 11:
Going all the way up.
Step 12:
Looping
Step 13:
Grab the top rubber band and loop it.
Step 14:
This is what it should look like when you are done loop ing one starburst
Step 15:
When you are done looping all the starburst it should look like this.
Step 16:
Now lets loop the border bands. Don't worry, this part isn't near as hard as the part you just did. ;) first you get one of the side bands and loop it to it's original peg.
Step 17:
Any you go all the way up until it looks like this.
Step 18:
Then you do the other side.
Step 19:
Tie a rubber band on the end.
Step 20:
Pull it off the loom.
Step 21:
Give it a clip.
6 Comments
6 years ago
hey that really helped me thank you
7 years ago
that didn't help at all
8 years ago on Introduction
You don't have to tie the band
8 years ago on Introduction
Not even helpful at all.
9 years ago on Introduction
thank you
9 years ago
I hope y'all liked it!:)))