Introduction: Leather Cat Card Holder

About: We are a professional leather pattern design and tool development studio, we offer high quality pdf, acrylic patterns, and high quality leather tools. We have 2 online stores: www.l…

You can have this acrylic pattern from here:

The finished size is about: 4.3" x 3.5" x 0.6" (11cm x 9cm x 1.5cm).


Hardware: 655 Snap x2, 10cm No.3 zipper x1, No.3 slider x1.

Leather: We advice 1.0mm (2.5oz) leather, size 22cm x 18cm.

Tools: If you are a new leather player, try to considerate to have tool kit here:

Step 1: Let Me Show You How to Make a Close-end Zipper.

Step 2: Cut All Leather Pieces From Acrylic Pattern and Punch Stitching Holes by Chisel, Here I Draw Some Decoration Lines Already, Sew One Side Cloth on Back Piece.

Step 3: Then Sew the Other Piece on Front Piece.

Step 4: Install 633 Snap on Grain Side of 1 Claw, and Glue 2 Claws's Flesh Side Together. Here Please Notice, Install Cap and Socket Together, I Had Split Cap Part to Get a Flat Cap.

Step 5: Now We Can Install 633 Snap Eyelet and Stud Together on Face, Also Sew Nose on Face.

Step 6: Now We Can Glue 2 Claws, Fold Front and Back Leather, Sew Pre Sewn Claws On, Here Please Notice That, When You Pre Sew Claw, Left an Opening, We Should Sew the Opening With Zipper.

Step 7: Sew Face on Front Piece, and Sew Left Stitching Holes, Finish.