Nail Painting Board.

5,212

20

6

Introduction: Nail Painting Board.

It is often useful to have this board of nails to support articles upon after you have painted or varnished them. Here is the quick way to make one.

Step 1: Choose Board Size and Nails.

I am painting relatively small items here so this board is rough 16 x 12 inches. brad nails are great because they have the smallest heads.

Step 2: Measure Out and Bang in Nails.

choose a spacing that is appropriate for your object to be supported. 1 inch works well for many things.

Be the First to Share

    Recommendations

    • Toys & Games Contest

      Toys & Games Contest
    • Big vs Small Challenge

      Big vs Small Challenge
    • Fix It Challenge

      Fix It Challenge

    6 Comments

    0
    dschwant
    dschwant

    15 years ago

    An alternate method is to: 1) Choose longer brads/nails 2) Drill pilot holes completely through the wood - just big enough to snuggly hold the nail. 3) Hammer the nails all of the way flush, so they are sticking out the other side. The trick here is to find a support for the wood, either on the edges or between the holes, so you have clearance underneath to get the nails through into an open space. The benefit of this method is that you have only a point (instead if a head) touching your newly painted pieces.

    0
    foobear
    foobear

    13 years ago on Introduction

    that's a pretty good idea. much better than setting the object on a paper towel or something like that.

    0
    Llamarama
    Llamarama

    13 years ago on Introduction

    I find that the best thing to use is a couple of strips of carpet tack rail. Its quite cheap too and has about 1/2 inch fine tacks on it, just glue them to a board!

    0
    mcarr
    mcarr

    14 years ago

    Here is an easier way. Get a piece of 3/4" pine and shoot a clip of 1-2" brads through it with a brad nailer. The whole board is ready in a few seconds.

    0
    burchb
    burchb

    15 years ago

    I like the point end up, but what about slightly bigger holes, but only half way through the board. Sort of a peg board with nails. The nails could be only inserted, head side down, so you can move the nails around as you need. Maybe only a couple at the corners instead of all over. Haven't tried, but just an idea.