Introduction: Rainbow Loom Triple Single

About: Follow me in Instagram, which is CindyyNguyyenn

Let's make a triple single! You'll need, your loom, hook and bands. And one C/ S clip.

Step 1: Bands

Grab 12 bands of your color and make sure the loom arrow is facing up. Start by placing your bands on the left side. Go all the way up. Do that for ALL three sides

Step 2: Bands Going Across

Take some more bands, skip the first 3 at the bottom. Take your band and make kind of a upside down triangle going all the way up.

Step 3: Hooking

Your going to spin your loom around. Grab your hook and start hooking on the left side. Reach all the way down and grab the band and place it to the next peg. Do that the entire way up. Do that same step for the middle and right side.

Step 4: Hooking the 3

At the top you will see 3 hooked bands not attached. You are going to grab the left band and place it on to the middle same with the right. Be VERY careful do not let go of your bracelet it could fall apart.

Step 5: Taking It Off

Take another same color band and place it on your hook and pull it through all the bands at the top. Take the half of the band and place it on the hook. Put your bands on the thicker part of the hook and CAREFULLY pull off your bracelet be gentle so you don't snap Any bands.

Step 6: Extension

It's probably not long enough for you, so you are going to take some more bands and loop them through the bands on your hook. Do that until it is long enough for your wrist. Then take a C/S clip and attach it to both ends.

Step 7: FINISHED!!

You are now finished your bracelet! Enjoy! Check out my other bracelets. Request any other rainbow loom bracelets.Please follow and like, also please please follow me on Instagram!
Username: CinCoCaLa08