Introduction: K'nex Bookcase
* The bottom of this bookcase is not so firm. I have done it because the box always on a flat surface.
* The top of the bookcase is very sturdy.
* This box is intended for little books, such as dictionaries.
* If you are going to make this, I wish you the best of luck!
don't forget to vote!
Step 1: Piece Count
This is about. Numbers may vary.
Connectors: (684)
Red: 14
Green: 2
Yellow: 220
Purple: 174
Blue: 234
White: 40
Rods: (1.351)
Green: 808
White: 417
Blue: 114
Grey: 12
Total: 2.035
Step 2: Lower Part
...
Step 3: Middle
I can make no instructions from here, because it is built on top of each other. If you want more pictures of this, please send an email.
Step 4: Top
Last step
Step 5: Finish!
* Have you built? Send a photo!
* Comments?
Participated in the
Makerlympics Contest
Participated in the
Organization Contest