True Trigger Knex Uberti 1871 Rolling Block Target Pistol by Bannana Inventor

4,982

7

34

Intro: True Trigger Knex Uberti 1871 Rolling Block Target Pistol by Bannana Inventor

This is a 1871 Uberti pistol it has a cocking lever and a true trigger. It is only a one shot just like the real gun. Unfortunately this gun is not very powerful. The reason is because of the what I think is new cocking design. Feel free to modify it if you want. ENJOY :D

Step 1: Building the Ram ,Trigger,and Handle

1.) Build the two halfs of the handle, then connect them together.

2.) Build the trigger.

3.) and 4.) Build ram. Four is just a side view.

Step 2: Building and Connecting the Body and Barrel.

1.) Build the body as shown.

2.) Build the two pieces of the barrel, you will connect in the next picture.

3.) As I said connect the barrel as shown.

4.) Now connect the barrel to the body. Pay close attention to which part of the body goes on which side.

Step 3: Adding Rubber Bands.

Add the rubber bands the trigger, and the handle where shown. Now you are done.

HOW TO SHOOT:
To shoot this gun all you do is put your on the red and yellow pieces of the ram and pull back until you see or hear the block move down. Now load a round in the barrel and pull the trigger.
(I am not held reliable for misuse or injury from this gun.)

THANKS FOR BUILDING!!! :D

Share

    Recommendations

    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Optics Contest

      Optics Contest
    • Audio Contest 2018

      Audio Contest 2018

    34 Discussions

    0
    None
    blackboard

    7 years ago on Introduction

    dude trigger sucks so dose the pull back thin my advive is remove the pull back thing and just add an orang cannector to a grey rod and done

    0
    None
    blackboard

    7 years ago on Step 3

    how do u work the trigger my not working and i bulit it exactly the same

    0
    None
    king of knex

    7 years ago on Introduction

    cool gun. word of advise:your silvery-green rod looks like it is gonna snap. DONT LET THAT HAPPEN!!! :)

    0
    None
    uberrobodude

    8 years ago on Step 3

    Mine went about 5 in with a new #64 rubber band. It slowed down near the end a lot. Do you know why?

    Hey does anyone know where i can buy those black Y clips and the other ones that look like it that use ball joints?

    0
    None
    mettaurloverrik3098

    Reply 9 years ago on Introduction

    same thing as an orange connector. that's the metallic version of it. some guns look really cool if you use those instead of oranges.

    0
    None
    agent47.

    9 years ago on Introduction

    bannana inventor your the best knex inventor on this site

    0
    None
    knex maddo

    10 years ago on Introduction

    i built this gun there are some problems... not powerful enough went about 10 foot i use 6 elastic bands!!! i broke aswell but still works(its works better broken for me it went 20 foot) over all the gun is good 4 star!!!

    4 replies