Failx

You can click on the picture of the first step, the dimensions are tagged on the piece itself via an instructable marking

The hinges of the table are spring supported. These ensure that the hinges remain stable in the unfolded state. The force when unfolding corresponds to the weight of the table top. The springs could possibly be replaced by stronger springs to reduce the necessary force.

Thank you!to be honest, the welder and electrodes are probably older than me, so the angle grinder was the most important tool for me :D

no, tipping over has not been a problem so far, even with a lot of weight on one side. The table has a high weight and therefore it is very stable. For reference, the box of water bottles on top weight 17,1 kg.

Thank you! :)

The image for the Red Card is self-made, I´ve used an image of a christmas tree and insert the stars in different sizes.For the Green tree I´ve used the image: https://www.facebook.com/sweeterhamburg/photos/1138534532992281

Thanks for your comment and for pointing out the error. I am happy when my projects are well received by others. Then the effort that is associated with it is worth it. I have added the connector. Best regards

A wooden wrench supposed to do what? Also as a mounting for something?

The wire springs back well and so far it has not lost any strength. I can't say if the wire will wear off, spring steel would be the better choice, but I only used material I still had at home.

Thank you very much :)

Thank you, I have added the dimensions, the diameter of the rod is 0.15 "

muchas gracias :)

Thank you :)

Thank you :)

Thank you :)

I have added measurements to the most important parts, you can find them on the pictures of step 1. thanks for the comment :)

Due to the washers the distances remain constant, therefore this cannot happen :)