florlayamp

The pins are the same in either version of plug if I remember. It’s been so long since I messed with it. From what I’m thinking is going on with the warnings is that this thing remembers the last signal it got before it got turned off. In your case maybe there was a front end wreck or something it registered. I have no idea how one would reset the signal.

Wow that looks amazing! Great job! The warning lights are hard to get off, I think it’s because it’s looking for the sensors or modules and it can’t find it perhaps? There’s probably a way to trick it by taking some wires to ground or putting bolts on them but I’ll have to take a look further into it!

Awesome! I'm not sure how to make it dimmer. The easiest thing to do would be to put a tinted plastic lens or something over the display. that way there's no need to rewire it or anything. That being said I know it has the capability to dim as it would in the vehicle but I haven't done any research on how it does that.

Hey, sorry I don’t monitor this enough as I should. So does it come on at all when you apply 12 volts to the pins 2 and 3? I had a power supply that wasn’t quite enough juice and it would take the unit 3 minutes to come on with it. You need some decent current to get it to come on. It worked in the jeep so it should still work. Have you tried connecting it directly to a car battery?

haha it tries to but gives up, it says brake light failure for about a minute when i first turn it on but it goes away until i turn it off and back on.