Introduction: Chinese Crown Knot Cross
The shape of the Chinese crown knot lends itself to this project
Step 1:
I used 3' of 3/16" cord.
Take the right hand strand over the left
Step 2:
and make a bight underneath the same cord
Step 3:
Take the other strand and bring it up underneath three - and down over two and through the bight
Step 4:
Adjust the bight to the desired shaape
Step 5:
Take the left hand cord and make a "S" shape
Step 6:
Bring the end up and down over, under, over the "S"
Step 7:
Then up under three
Step 8:
Then down over two and through the bight. Adjust the size of the loop
Step 9:
Take the right hand cord and make a "S"
Step 10:
And bring the end up and down over, under, and over the "S"
Step 11:
Bring the cord up under the three strands of the "S"
Step 12:
and down over two and through the bight. Adjust the size of the loop
Step 13:
Bring the right hand cord over . . .
Step 14:
And make a bight under the other cord
Step 15:
Bring that other cord up under three
Step 16:
and down over two and through the bight
Step 17:
repeat the above steps making two more crowns
Step 18:
There are many ways to finish.
Leave the ends alone.
Tie any two strand stopper knot