Introduction: K'Nex Differencial (Version 1)
Car differencial built from k'nex for k'nex vehicle by Forsterimages. Here is what your finnished diff. will look like. Also see version two.
Step 1: Parts Required
Here is a list of the parts you will need:
4 white connecters,
2 brown cog wheels,
2 grey cog wheels,
2 orange connecters,
4 navy rods,
2 yellow rods,
4 silver spacers,
8 blue spacers,
8 black connecters,
2 yellow cog wheels,
some blue tack.
4 white connecters,
2 brown cog wheels,
2 grey cog wheels,
2 orange connecters,
4 navy rods,
2 yellow rods,
4 silver spacers,
8 blue spacers,
8 black connecters,
2 yellow cog wheels,
some blue tack.
Step 2: Step One
Take one of the white connecters and attach to black connecters opposite each other. Do this for times.
Step 3: Step Two
Take two of the pieces you made in the last step and connect them together using two navy rods. Make two of these.
Step 4: Step Three
Attach one grey cog wheel to the end of a yelloew rod and the slide two blue spacers onto the rod. Do this twice.
Step 5: Step Four
Attach two grey cog wheels to the end of a navy rod. Then place a blue spacer on each end of the rod. Place some blue tack around the end of the rod.
Step 6: Step Five
Now place a red connecter on each end of the part you made in the last step.
Step 7: Step Six
Take the parts you made in steps four and five and join them together as shown making sure to place a grey spacer o the ends of the navy rods. Do this twice.
Step 8: Step Seven
Now take the parts you made in steps five and six and join them together as shown.
Step 9: Step Eight
Take the other part you made in step six and attach it to the other side like in the last step.
Step 10: Step Nine
Now place on yellow cog wheel on either end and your done. Now you can attach two wheels. By (c)Forsterimages.