Introduction: K'nex Piston Lift With Instructions.

By autumsawesome
About: Hello everyone, I am autumsawesome. I have made bread, jam, omelettes and even an alcohol stove out of pop cans,

This is a Knex lift I will use in my new ballmachine "Carbon"

Here is a video of it in action.

Hope you enjoy it ( ;

Step 1: Entrance

Build this.

Step 2: Exit

Follow pictures.

Step 3: Pistons Part 1

Build this.

Step 4: Piston Part 2

Build this.

Step 5: Piston Part 3

Connect them.

Step 6: Main Frame

Build half of the main frame.

Step 7: Piston Arm

Build this.

Step 8: Piston Arm

Build it.

Step 9: Ball Rail

Build it.

Step 10: Connecting Them Together

Connect them.

Step 11: Piston Arm

Build it

Step 12: Placing the Piston Arm in the Main Frame

Slide it in.

Step 13: More Main Frame

Build it.

Step 14: Put It Together

Connect them

Step 15: Attach the Entrance

What the title says.

Step 16: Attach the Piston Arm

Connect it.

Step 17: Attach the Pistons

Attach it on the top and attach two yellow rods.

Step 18: Connect the Pistons

Step 19: The Other Side

Build it.

Step 20: Even More Main Frame

Build it.

Step 21: Step 21

Build it... I'm getting board

(Pun intended)

Step 22: Step 22

Connect them

Step 23: Connecting the Second Piston Arm

Follow the pictures.

Step 24: The Third Last Step

Connect the together like this.

Step 25: Second Last Step

Attach the exit.

Step 26: A Few More Pictures

Here are a few more pictures but the last step is to:

Comment

Subscribe

Like