That's awesome! I'm glad the plans worked out. Can you send a picture in the comments? I'd love to see how they turned out.
Yep that's right. I wanted the chair to be really comfy so one could sit in it for hours without feeling discomfort, so I did my research beforehand. I found this helpful resource: https://www.core77.com/posts/43422/Reference-Common-Dimensions-Angles-and-Heights-for-Seating-Designers and used it for the dimensions of the prototype and then made some slight adjustments for the final build.
JF Time Fountain
3D Printed Magnetic Levitation!
Japanese Family Name Plate
DIY Hollow Face Illusion!
Build a Warped Box!
Mid-Century Modern Lounge Chair
Thanks, I really appreciate it!
Thanks for bringing this up! I too was concerned about this during the build, and I found Matthias Wandel had a great resource on wood joint strength (https://woodgears.ca/joint_strength/). Like stumitch said, dowel joints are pretty strong. They can take a lot of shear force due to the penetration of the dowel into the wood. As for lasting decades, it depends on how long the glue holds. Dowel joints depend on glue for strength (as opposed to dovetails for example), and if the glue bond is weakened, then the joint falls apart. Wood glue should hold joints together for decades, but as we see with joints falling apart on old furniture, longevity is not guaranteed. These doweled joints will definitely hold up in the short term but in the long run we'll just have to wait and see.
No problem! I'm glad your able to relate with this chair and this Instructable is going to good use!
Haha your totally right! That glue up took a lot of eyeballing and I wasn't able to make too many adjustments before the glue became tacky. When I got home, I was so worried that it wasn't lined up that I analyzed the single photo I took. I annotated the photo by extending lines from the legs, and if all the lines I drew met at a single focal point, then everything was parallel. It was pretty close and I guess I got lucky in the end!
Thanks you, I appreciate your feedback!
Thanks you! It's very comfortable, especially with a footrest, I could sit in it all day :)
Thanks! Yep, signing a piece can make the difference between a product that is unremarkable and one that will always have a story to tell.
Thank you! I love projects that look great and are fully functional too.
Thanks Ross! I'll get the files up by tomorrow. I wanted to make sure they were perfect before I released them. Here's a sneak peek... :)
That's awesome! Please let me know if you have any questions and send a picture when your done!
Mid-Century Modern Lounge C...
Japanese Family Name PlateView Instructable »
Capers II, a Hexapod Robot
Thanks for your feedback, I really appreciate it. I made edits to the the process in steps 2-4 to make it easier to follow.
Touch-sensitive LED Lantern
Unfortunately, I didn’t take any pictures of the cutting process. But you can check out https://youtu.be/GCZtB8qLydY where Peter Brown shows how he made a cutting board with a similar pattern.
Thank you, I really appreciate it!
Awesome, I’m glad you liked it! Let me know if you have any questions.
Thanks for your kind words!
Yep, they add structural integrity but don’t get in the way of the design!
Sculpted Oak Desk
A 3D Printed Quadruped Robot
Build a Warped Box!View Instructable »
WiDC - Wi-Fi Controlled FPV Robot (with Arduino, ESP8266 and DC Motors)
IoT Controlled Lamp
Blooms: Phi-Based Strobe Animated Sculptures
Homemade Table Tennis Robot for ~$230
Arduino Self-Balancing Robot
How I Make Cool Metal Inlays