Thank you! I kinda like working with wires in 3 dimensions like putting pipes thru a house. It requires lot of creativity :)
Really nice build!
Really nice build, man! Yes, you are right D0 and D1 are usable as well if you don't need serial debug, which I like to use :)
Sure, 860ohm resistor is a current limiting resistor to prevent Arduino pin from burning out from static electricity. I think anything between 200-1000 ohms is just fine.The other 10M resistor configures the sensitivity of touch sensor, values from 1M to 22M should work.
Saturn V Lamp
Hi, it's so obvious, how can I even write such code? :D Byte type can only stores values from 0-255. That means that -1 in array does not make sense, some compiler will allow it some not, change the type of array to int8_t, does it helped?
Good job man!
Make it! :)
Arduinoflake - PCB VersionView Instructable »
Glowing OrnamentView Instructable »
Hi, I am impressed! Really great job man, I love it! Seems like an exact copy of mine :)How long does it take? Any major problems?As for 'circuit sculpture' contest, yes I've submitted my Arduinoflake there.
Thank you! Yes, I did not have a battery pack when making these photos and also the wire and connector acted as a support. Let me know what you've made!
Hi, soon enough, I've done some updates and now it's waiting for review.
It is surprisingly rigid, I was very pleased with the result. I didn't have a 1M THT resistor at the moment so I used the SMD one, and it was a mistake! It looks nice but it broke several times, the pads on an SMD resistor are very easy to break. I actually replaced that with a THT resistor in later upgrade :) Let me see your build once done!
Sure why not, as long as you are able to solder them together
It's the largest diameter that can fit into Arduino Nano holes. It very flexible but pretty strong once done intro such construction.
See schematics, there is specification for each part. There is only 4 part types :)
Thank you, its Hebei 599XW7C try to lookup it in your favorite shops, I've purchased it here in the Czech Republic.
The ones I purchased come in straight rods, so I only need to bend them.
Added few more detail pics to Construction step, check them out!
It has cool layout but too little I/O pins
Arduino Energy Cost Electrical Meter Device
ArduinoflakeView Instructable »
Wake Me Up LightView Instructable »