Introduction: Diy Rings – Fun Easy Crafts
Step 1: Cut Three Pieces of Cords That Are at Least 50 Cm Long. Keep Each Piece of Cord the Same Length and String Two the Jadeite Jade Beads.
Step 2: Tie an Overhand Knot at the Tail of Cord in Case the Jadeite Beads May Slip Off.
Step 3: Repeat the Same Processor on the Other Side.
Step 4: As Shown in This Image.
Step 5: Fold Them in Half and Tie the Six Cords Together With Another Cord.
Step 6: Start Braiding Your Ring by Using the Flat Knot.
Step 7: Stop Braiding When You Reach Your Desired Length.
Step 8: Cut the Loose Ends of Cords Off and Burn Tails of Cords.
Step 9: Move the Jadeite Jade Beads in Middle Place and Tie an Overhand Knot.
Step 10: Repeat the Step 8 Till All the Jadeite Jade Beads Are in the Place.
Step 11: Trim the Excess Cords and Burn the Tails of Cords.
Make it Glow Contest
First Time Author Contest
Anything Goes Contest