more powerful, portable amp Answered
I was messing around with some op-amps, building variations of the CMoy amp, etc. But I became depressed quickly -- these ICs' data sheets say that at the safe maximum of 15 volts, they can only pump out around 1/4 watt of power on a single channel! Well, i have a full range driver that really needs more power to sound decent. I was wondering what the normal way of constructing an amp would be if I were looking for 5 to 10 watts of power. *edit*: i'm not looking to run this thing off of batteries... i'm sure at 10 watts, a couple of D cells would get drained rather quickly... I recently cracked open an old 4.1 computer sound system (by microlabs) and scrapped the 5 drivers (4 satellites and a 5 inch sub), two big 3700 uF caps, and two JRC4558D dual op-amp ICs from the amplifier. I read up on the JRC chip (actually, just the data sheet from the RC5448D, the texas instruments flavor, i guess the JRC is discontinued) and it seems that this thing only puts out a max of 200 mW per channel, and typically around 90 mW. Ok i know those speakers didn't get THAT loud without distortion, but i am CERTAIN it was more than 800 mW for those 4 satellites. I am a new computer engineering student, so i can understand the physics behind the electronics, but i am nowhere near the level to start reverse-engineering that amp board. So how did these speakers get driven so hard? THANKS for reading!!!!!